top of page

Rigging a bridle

On this page we will show you the fundamentals of rigging up a bridle. There are many ways to skin this cat but we will show you a couple of tried and tested methods that will even serve you well when you are out in the middle of the big blue and need a quick fix

Here is a list of items you will need for this tutorial:

  • Dyneema bridle cord - This can be purchased from most spearfishing outlets and comes in a range of sizes depending on preference. We will usually use 1.8mm diameter dyneema cord

  • A sharp knife and a lighter - used for trimming and finishing

  • Silicone spray - Used to lubricate the internal rubber for ease of bridle insertion

  • Needle nose pliers - used for bridle insertion

  • If using beads, a wishbone - used for bead insertion

Cutlery

Creating your bridle

_edited.jpg

Create a loop with your dyneema, roughly 4 inches long

Step 1

IMG20220709102543_edited.jpg

Whilst pinching the 2 cords together at the base of the loop, rotate the loop 360º around the base

Step 2

IMG20220709102642_edited.jpg

Pass the loop through hole created by "Step 2" and pull tight, ensuring you end with 1.5/2 inches of loop above the knot

Step 3

IMG20220709102642_edited_edited.jpg

Rearrange the knot so that it sits straight, then trim off excess cord and use the lighter to seal the cord ends to prevent fraying. Then repeat steps 1 to 4

Step 4

IMG20220709102934_edited.jpg

In the end of new dyneema cord, tie a single knot. measure 4 inches then tie another. trim excess cord close to the knots remembering to seal the ends with the lighter. This is your bridle

Step 5

IMG20220709103431.jpg

Spray the internal holes of the bands with the silicone spray to allow for easy insertion of the loops

Step 6

IMG20220709103550_edited.jpg

Using your needle nose pliers, clamp the "figure 8" knot of the bridle loop and ease it into the end of the rubber. One in each end. Then, whilst pushing the pliers outwards, ease them out, ensuring the knot stays in the rubber. You want the knot to sit at least an inch from the end

Step 7

IMG20220709103844_edited.jpg

Pass the end of your bridle through one loop, rotate around the loop 360º then pass between itself and the loop. Pull tight. Repeat this with the other end of the bridle and 2nd loop

Step 8 

Once completed, don't forget to tie your constrictor knots! Click below to see how

bottom of page